Bike Not Starting After Wash: Possible Reasons And Their Solutions

If you’ve washed your motorcycle and are now having trouble getting it to start, you’re not alone.

This is a common issue that can be caused by a variety of factors.

In this article, we’ll take a look at some of the most common causes of this problem and how you can troubleshoot and fix it.

Reasons Why Your Bike Is Not Starting After Wash

There are a few potential reasons why your bike might not start after being washed. Some common causes include:

1. Water in the spark plug wells: If water gets into the spark plug wells, it can prevent the spark plugs from firing properly, causing the engine to fail to start.

2. Water in the fuel system: If water gets into the fuel system, it can cause the fuel to become contaminated, which can prevent the engine from starting.

3. Wet electrical components: If the bike’s electrical components (such as the ignition switch, wiring, or battery) get wet, they can short out or become damaged, which can prevent the engine from starting.

4. Corroded connections: If the bike’s connections (such as the battery cables or spark plug wires) become corroded, they can prevent the electrical current from flowing properly, causing the engine to fail to start.

How Do You Start A Bike After Water Wash?

To start a motorcycle after it has been washed with water, follow these steps:

1. Dry the bike: Be sure to dry off the bike as much as possible before attempting to start it. Use a towel or chamois cloth to wipe down the engine and electrical components, paying particular attention to the spark plug wells, ignition switch, and wiring.

2. Check the spark plugs: Remove the spark plugs and check for water or corrosion. If they are wet or corroded, clean them or replace them as needed.

3. Check the fuel system: Check the fuel filter and fuel lines for water or contamination. If they are dirty or contaminated, clean or replace them as needed.

4. Check the electrical components: Check the ignition switch, wiring, and battery for damage or corrosion. If any of these components are damaged or corroded, repair or replace them as needed.

5. Check the connections: Check the battery cables and spark plug wires for corrosion or lose connections. If they are corroded or loose, clean or tighten them as needed.

6. Attempt to start the bike: Once you have checked and addressed any potential issues, try to start the bike as you normally would. If it doesn’t start, check the spark plugs and fuel system again to ensure they are functioning properly.

If you are unable to start the bike or are unsure how to perform these checks, it is recommended to take the bike to a mechanic for further inspection and repair.

How Do You Dry Off A Motorcycle?

To dry off a motorcycle after it has been washed with water, you can follow these steps:

1. Wipe down the bike: Use a towel or chamois cloth to wipe down the surface of the bike, including the bodywork, frame, wheels, and tires. Be sure to get as much water off the bike as possible.

2. Dry off the engine and electrical components: Pay particular attention to the spark plug wells, ignition switch, and wiring, as these areas are prone to water damage. Use a towel or cloth to carefully dry off these components.

3. Air dry the bike: If the bike is still wet after wiping it down, you can allow it to air dry. This can be done by parking the bike in a warm, dry place and allowing the air to circulate around it.

4. Use a hair dryer or heat gun: If you need to speed up the drying process, you can use a hair dryer or heat gun to blow warm air over the bike. Be careful not to hold the hair dryer or heat gun too close to the bike, as excessive heat can cause damage to the paint or plastic.

How Long Does The Engine Dry After Washing?

It can take anywhere from 15 minutes to half an hour for an engine to dry completely after being washed with water. The length of time it takes will depend on several factors, including the ambient temperature and humidity, the amount of water that was used to wash the engine, and the effectiveness of your drying efforts.

Leave a Comment

Your email address will not be published. Required fields are marked *